I thought I already posted this a couple of days ago. If you are here because you google searched these error messages on your display screen. I had no idea about this before today and it is definately NOT in the chapter of the Mazak book that I read. for someone like me with little/no experience. While this may be an every day common sense thing for 99% of you all. Once the tool was above the pipe, I was able to take my finger off of the middle button, press the reset button and everything cleared out. I pressed the jog button (10x speed) and flipped the toggle switch to X axis and began spinning the control wheel clockwise moving the tool up by hand.

Once the screen came online I released my finger from the reset button and continued to hold it on the middle button. Now I hit the on button located on the monitor.

Next I pressed down and held the reset button and the button right below it. I did a full power down on the machine, waited a couple minutes for all the capacitors to drain and hamsters to fall asleep and then powered back up on the main disconnect. The reset will not clear until the tool is moved but I can't move the tool until the reset is clear! So now we are in an interesting position. this was not going to reset until the tool arm was above the pipe. an operator over extended the tool (pictured below) The alarm book did not provide the solution I needed, however, the solution was found and I want to share it incase anyone else might find themselves in such a position.īasically. I came into work today and the Mazak was down (again) with two errors.Įrror 121 Overtravel and 023 Illegal memory 1.

Mazak alarm codes 371